Difference between revisions of "Translations:Dual Extruder single nozzle/10/en"

From 3Dator Wiki
Jump to: navigation, search
(Die Seite wurde neu angelegt: „The slicer configuration is based on Slicer configuration.“)
 
 
Line 1: Line 1:
 
The slicer configuration is based on  [[Special:MyLanguage/Slicer_Voreinstellungen|Slicer configuration]].
 
The slicer configuration is based on  [[Special:MyLanguage/Slicer_Voreinstellungen|Slicer configuration]].
 +
You can download a precofigured profile for Simplify 3D [https://github.com/3Dator/3dator/blob/master/Slicer%20profile/3Dator%20Y%20Dual.fff here] .

Latest revision as of 11:40, 27 April 2017

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Dual Extruder single nozzle)
Die Slicer Einstellungen basieren auf den Standarteinstellungen von [[Special:MyLanguage/Slicer_Voreinstellungen|Slicer_Voreinstellungen]].
Ein vorgefertigtes Profil für Simplify 3D kann [https://github.com/3Dator/3dator/blob/master/Slicer%20profile/3Dator%20Y%20Dual.fff hier] heruntergeladen werden.
TranslationThe slicer configuration is based on  [[Special:MyLanguage/Slicer_Voreinstellungen|Slicer configuration]].
You can download a precofigured profile for Simplify 3D [https://github.com/3Dator/3dator/blob/master/Slicer%20profile/3Dator%20Y%20Dual.fff here] .

The slicer configuration is based on Slicer configuration. You can download a precofigured profile for Simplify 3D here .